Single Phase Full Wave SCR - RL Load

COMPONENTS

AC Source

Thyristor

Gate Pulse

Resistor

Inductor

Voltmeter

Ammeter

Ground

OBSERVATION TABLE

S.No.	VL_rms (V)	IL_rms (A)	VL_avg (V)	IL_avg (A)

IL

17

18

VT1

5

6

9

7

8

T1

10

GP1

VT3

11

12

T3

15

13

14

16

GP3

VGP1

19

20

21

GND1

37

38

R

VINP

1

2

3

4

AC

41

42

VLOAD

VGP4

34

35

36

GND2

39

40

L

VT4

22

23

T4

26

24

25

GP4

27

VT2

28

29

T2

32

30

31

GP2

33

STEP 1: Drag and drop the components in the workspace to create the circuit.

Nos of required components:

AC Source – 1, Thyristor – 4, Gate Pulse – 4, Resistor - 1

Inductor - 1, Ammeter – 1, Voltmeter – 8, Ground - 2

STEP 2: Make the connections as per the instructions given below:

(a) (01-03, 03-08, 02-04, 08-24, 14-30)

(b) (04-30, 05-07, 06-08, 07-17, 13-17)

(c) (18-37, 09-10, 11-13, 12-14, 15-16)

(d) (10-19, 20-21, 22-24, 23-25, 26-27)

(e) (27-35, 34-36, 28-30, 29-31, 32-33)

(f) (25-31, 31-40, 38-39, 37-41, 40-42)

STEP 3: Click on the CHECK button to check the connections.

Note: Right click on the component to open the dialog box to edit the properties of the component.

STEP 4: Input the values for all the required components (AC Source, Gate Pulses, Resistor and Inductor) and the waveform will get plot automatically.

STEP 5: Now, Click on the ADD button to insert the reading into the observation table.

STEP 6: Now, you can input different values as per your requirement to get the desired waveform.

STEP 7: Repeat Step 5 to again insert the reading into the table and now repeat Steps 6 to 7 to take more readings.

STEP 8: Click on the PRINT button to take out the print of the webpage.

STEP 9: Click on the RESET button to reload the webpage.